(Notice that the esp8266 and led stripe share the same ground).Ĭode Setup Step 1) Open the arduino IDE and go to setting / preferences. Step 10) Take the other end of that wire and place it in (28, b) of the breadboard. Step 9) Take the other end of the male to female wire and put it into ground (white) wire of the led light strip. Step 8) Take the other end of the male to female wire and put that into D6 of the ESP8266. Step 7) Take the male to female jumper wire and hook it into the middle wire of the led light strip. But you should be able to (gnd) port on the board. Step 6) Take the other male to male jumper wire put into the breadboard (28, c) and ground (gnd) on the ESP 8266 Chip. Step 5) Hook the other end of the male to male wire into the breadboard (28, d). Step 4) Hook in the male to male wire to ground of the power adapter. Screw the wire down on the power adapter side. Step 3) Take male to male jumper wire and put one side into the positive end of the power adapter and the other end the red wire of led light strip. Step 2) Insert the DC Power Jack Adapter into the power cord. Project Setup Step 1) Put the ESP8266 Chip in the breadboard.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |